电感耦合等离子体原子发射光谱分析中光谱干扰校正卡尔曼滤波法研究

本文利用电感耦合等离子体原子发射光谱多色仪的扫描功能,用卡尔曼滤波法对各种光谱干扰进行校正。结果表明,该法能处理各种类型光谱干扰,不需要样品基体匹配,其测定回收率明显优于在峰法和离峰法,具有简便、准确等优点。     

A zero differential overlap study of chemical binding in ammonia-borane and carbony l-borane

A cndo/2D study of the charge distribution obtained through Mulliken population analysis in the ground state of the title compounds shows that the features of charge distribution found by severalab initio calculations are fairly well reproduced by this method. The one-particle density, the interference density at the mid-point of the bond axis and the kinetic part of the interference energy calculated through the deorthogonalized density matrices over a wide range of intermolecular separation between the donor and the acceptor show that the one-particle density and the interference density steadily grow with decreasing internuclear separation, while the kinetic interference energy starts with negative value at large distance, then decreases and passes through a minima near but above the equilibrium distance and then increases rapidly below it conforming to the characteristic general behaviour of the kinetic component of Morse curve. The orbital pairwise interference density and the corresponding kinetic energy components reveal that the orbitals involved in the covalent binding are σ_2p AO of B and 2S and σ_2p AO of N and C atoms in H₃B-NH₃ and H₃B-CO respectively.     

海底沉积物的ICP-AES分析

海底沉积物用硝酸-高氯酸-氢氟酸消解,然后用ICP-AES法同时测定常量和微量元素。研究了样品中基体元素对微量元素测定的光谱干扰,并采用干扰曲线斜率法进行干扰校正,分析批量海底沉积物样品获得满意结果。     

高纯氧化镝电感耦合等离子体原子发射光谱法摄谱分析时光谱干扰校正方法的研究

本文建立了高纯氧化镝样品ICP摄谱分析时干扰系数法校正光谱干扰的方法。测定了镝基体对14种稀土杂质元素20条灵敏分析线的干扰系数(KCT)。并有效地校正了镝基体造成的光谱干扰,获得满意的结果。     

毛细管电泳-激光干涉检测法测定饮料中蔗糖含量

本文将毛细管电泳-激光干涉检测法用于饮料中蔗糖的定量测定.结果表明,在样品浓度低于10mg/mL时,检测信号与样品浓度成正比.样品不需衍生化处理直接进行测定,分析结果较为满意.     

Radiation: Waves or particles? A quantized approach to time

A fundamental difficulty in theoretical physics is the dual and apparently incompatible interpretations of radiation as showing both continuous and extensive wave properties but also those of discrete atomic or smaller individual particles. Some of these contradictions are outlined. The explanation offered is of a quantized nature of time; units t_o=h/m_oc² for a particle at rest, and of similar interval unit s_o when in relative motion, with conventional relativistic corrections.

For many purposes this form of quantization replaces the need for a wave concept which then appears as a mathematical approach, chosen to avoid the physical concept of an intrinsicc time for any particle, just as we have for its intrinsic mass, spin and electrical charge. t_o and s_o are directly related to its frequency, energy and mass. The uncertainty principle and interference relations follow directly from this model, without any physical wave concept.     

Resolving the copper interference effect on the stripping chronopotentiometric response of lead(II) obtained at bismuth film screen-printed electrode

As copper(II) is a common ion in a variety of analytical samples, its effect on the stripping response of lead(II) at bismuth film screen-printed carbon electrode (BFSPCE) was investigated. The study was conducted using a screen-printed three-electrode system (working, counter and reference electrodes), with the carbon-working electrode plated in situ with bismuth film. Copper present at significant concentration level in samples was found to affect the sensitivity of the electrode by reducing the constant current stripping chronopotentiometric (CCSCP) response of lead(II). Recovery of the lead stripping response at the BFSPCE in the presence of copper was obtained when 0.1 mM ferricyanide was added to the test solution. The ferricyanide added circumvents the detrimental effect of copper(II) by selectively masking the copper ions by forming a complex. The analytical utility of the procedure is illustrated by the stripping chronopotentiometric determinations of lead(II) in soil extracts.     

Removal of humic matter interference in the determination of Cr(VI) in soil extracts by the diphenylcarbazide method

Alkaline digestion of soil samples, which is recommended for minimizing Cr(III)–Cr(VI) interconversions during the extraction of Cr(VI), may also solubilize humic matter (HM). The latter is responsible for both positive and negative interference in the analysis of Cr(VI) in the extract by the diphenylcarbazide (DPC) method. Humic compounds indeed absorb light at 540 nm as the Cr-DPC product and are also able to rapidly reduce Cr(VI) under the pH conditions of the standard DPC method. To prevent any risk of interference and make the DPC method applicable to soil extracts, a new protocol is proposed. This consists of three successive steps: (1) extraction of Cr(VI) by the U.S.EPA method 3060A in the presence of Mg²⁺; (2) batch removal of solubilised HM by the XAD-7 sorbent at pH 3.0 ± 0.1 with 3–5 min contact time; (3) analysis of Cr(VI) with the DPC method at pH 3.0 ± 0.1. The application of this new protocol to the soil product SQC-012 Lot 4 certified by R.T. Corporation (RTC, USA) gave significantly lower Cr(VI) concentrations and smaller variability compared to certified values (46.5 ± 2.3 instead of 153 ± 32.6 mg/kg). The new protocol was validated by Cr(VI) and Cr(III) spikes either to the soil/extractant suspension or to the exctract. Cr(VI) results in the wide range of acceptance limits (104–202 mg/kg) reported by RTC were only obtained when the U.S.EPA method 3060A without the addition of Mg²⁺ and DPC analysis at pH 1.0 were applied. The latter procedure appears questionable since it leads to largely variable results which reflect the complex role played by humic matter in the determination of Cr(VI) and the instability of Cr(III) during the extraction.     

ICP－AES中内标法的应用研究 Ⅲ．用内标法校正基体干扰

通过观测基体对分析元素发射强度的干扰情况，分析干扰机制，从而确定用来校正基体干扰的内标元素与分析元素的匹配条件。实验结果表明，只要选择合适的内标元素，可以校正基体干扰。     

Correction of iron interface in the spectrophotometric flow injection catalytic determination of molybdenum in plants

Iron interference in the spectrophotometric catalytic determination of molybdenum based on the iodide-hydrogen peroxide reaction can be corrected by using sulphosalicylic acid as masking and color-forming reagent. The catalytic influence of iron ions is circumvented to the extent of about 90% and correction of any remaining iron ions is possible by monitoring the colored iron(III)-salicylate complex at 490 nm. In this way, iron is also determined. With the proposed system, molybdenum can be determined in plant and food digests within the 0–100 μg Mo 1⁻¹ range in the presence of up to 25 mg Fe 1⁻¹, at a sampling rate of about 50 determinations h⁻¹. The relative standard deviation of 10 consecutive measurements was estimated as < 2%. Results for samples were comparable with those obtained by graphite furnace atomic absorption spectrometry. In addition, recoveries within the range 94–100% were calculated.